| purpose Reduce the mechanical loss, maintain the machine’s performance and accuracy, extend the life of the machine tool and find out the hidden failure of machine tool early, avoid causing more serious damage or danger. Matters of attention at work All measures should be taken to prevent non-staff from entering the project area, or even operating the machine, causing danger. If you need to open the electric control box, resistor disk, check or repair; Or have the opportunity to touch the parts of the machine power driven; The machine must be cut off to prevent electric shock or being hit by a machine. The cleaning machine should avoid using the air gun, because the iron dust will be blown up, and attached to the operating panel, the automatic tool change frame, the tool handle on the tool holder, etc., may cause the machine failure. If the machine makes an abnormal noise or vibration, please confirm its source and contact the service center of the company when necessary. When replacing parts, be sure to use the original parts. It is not only possible to damage machine tools and even accidents by using parts that are not original. Safety precautions Guaranteed voltage 380V stable, pressure 0.4-0.6 kg/cm and dry without water. The transmission computer must connect the ground wire without leakage and prevent damage to the main board. The machine is regularly buttered one month at a time, and you must use a specific type of butter. Tool and rivet must be locked, and accurate and reliable in the knife seat, otherwise it will damaged knife claws, the handle and the spindle taper hole must be kept clean, the cutting tool must be correct measurement to use long, cutter feed speed must be reasonable. The fixture must be in zero position and lock tightly. The workpiece must be properly mounted on the fixture. The program is prepared according to the process requirement, and the single step is good, and the correct test is correct before it can be put into production. Always pay attention to machine tools in production, do not crash. Do not change machine parameters arbitrarily. |